Mitsubishi GOT1000 Series Connection Manual page 879

2 Connector specifications
(1) GOT side connector
Use the following as the RS-422/485 communication unit connector on the GOT.
For the GOT side of the RS-422 cable, use a connector or connector cover applicable to the GOT
connector.
GOT
GT11
GT15-RS4-9S
GT15-RS4-TE
(2) YAMATAKE temperature controller side connector
Use the connector compatible with the YAMATAKE temperature controller side module.
For details, refer to the following manual.
User's Manual for the YAMATAKE temperature controller
3 Precautions when preparing a cable
The length of the RS-485 cable must be 500m or less
4 Connecting terminating resistors
(1) YAMATAKE temperature controller
Connect the terminating resistor on the YAMATAKE temperature controller side when connecting a
GOT to a YAMATAKE temperature controller.
Section 21.4 Temperature Controller Side Setting
(2) GOT
Set the terminating resistor of RS-422/485 communication unit using the terminating resistor
setting switch.
Terminating
*1
resistor
Enable
Disable
*1 The default setting is "Enable".
Refer view of RS-422/485 communication unit
Connector model
17LE-13090-27(D3AC)
17LE-13090-27(D3AC)
SL-SMT3.5/10/90F BOX
Switch No.
1 2
ON ON
OFF OFF
(When using GT15-RS4-9S)
SW1
Connector type
9-pin D-sub (female)
9-pin D-sub (female)
terminal block type
SW1
Terminating resistor setting switch
ON
21.2 Connection Cable
21.2.2 RS-485 cable
Manufacturer
DDK Ltd.
DDK Ltd.
Weidmuller interconnections inc.
21 - 23
17
18
19
20
21
22
23
24