8.3.2
Connecting to Ethernet module (QnA Series)
This section describes the settings of the GOT and Ethernet module (Q Series) given for the system
configuration shown at
Ethernet module (QnA Series)
1
System configuration
Switch setting of Ethernet module
[Network parameter] of GX Developer
*1
The Ethernet module is mounted on the base unit slot 0.
The Start I/O No. of the Ethernet module is set to "0".
.
For details of the Ethernet module (QnA Series), refer to the following manual.
For QnA Ethernet Interface Module User's Manual
[Communication settings] and [Ethernet setting] of GT
Designer2
*1
<Ethernet module> (The settings other than the following are
set to the default)
Network No.
: 1
PC No.
: 2
IP address
: 192.168.0.19
Port No.
: 5001
Communication format
: UDP(fixed)
8.3.2 Connecting to Ethernet module (QnA Series)
<GOT>(The settings other than the following
are set to the default)
Network No.
: 1
PC No.
: 1
IP address
: 192.168.0.18
Port No.
: 5001
Communication format
: UDP(fixed)
8.3 PLC Side Setting
1
2
3
4
5
6
7
8
8 - 25