Precautions - Mitsubishi GOT1000 Series Connection Manual

27.4.11 Precautions

1 Via network system
GOT with Ethernet communication cannot access the CNCs in another network via the CNC (network
module, Ethernet module, etc.).
2 When connecting to multiple GOTs
When connecting two or more GOTs in the Ethernet network, set each "PC No." to the GOT.
Section 27.4.5 Setting communication interface (Communication settings)
3 When connecting to the multiple network equipments (including GOT) in a segment
By increasing the network load, the transmission speed between the GOT and CNC may be reduced.
The following actions may improve the communication performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)
• Reduction of the monitoring points on GOT
4 Ethernet cable connection
Ethernet cable is so susceptible to noise that you should wire power cables and electric supply cables
separately. And you need to attach a ferrite core (attachment) on the control unit side.
For details of the Ethernet cable connection, refer to the following
MELDAS C6/C64 NETWORK MANUAL BNP-B2373 IX Connection Function with GOT
LED1
5
Version of CNC
For MELDAS C6/C64, use NC system software version D0 or later.
1 turn
Ferrite core
Ethernet
FG cable for Ethernet
GOT
Ferrite core
27.4 Ethernet Connection
27.4.11 Precautions
25
26
27
28
29
30
31
27 - 83