Mitsubishi GOT1000 Series Connection Manual page 955

2 Connector specifications
(1) GOT side connector
Use the following as the RS-422/485 communication unit connector on the GOT.
For the GOT side of the RS-422 cable, use a connector or connector cover applicable to the GOT
connector.
GOT
RS-422 conversion unit
GT11
GT15-RS4-9S
(2) Inverter connector specifications
(a) Pin layout in the PU port
When seen from the front of the inverter
(receptacle side)
Modular jack
The contents inside ( ) indicate symbols described in the inverter manual.
The pins number 2 and 8 (P5S) are connected to the power supply for an operation panel or a
parameter unit. Do not use them in RS-422 communication.
(b) Connector of cable between FREQROL Series inverters
Use the commercial connectors and cables shown in the table below or the comparable
products. (Refer to the manual for the inverter.)
Introduced products (as of October, 2005)
Name
Connector
Modular ceiling rossette
Cable
Connector model
17LE-13090-27(D3AC)
17LE-13090-27(D3AC)
17LE-13090-27(D3AC)
Pin No.
1
2
3
4
5
6
7
8
Model name
5-554720-3 RJ45 conector
BMJ-8
Cable conforming to EIA568
SGLPEV 0.5mm 4P
(such as cable 10BASE-T)
Connector type
9-pin D-sub (female) DDK Ltd.
9-pin D-sub (female) DDK Ltd.
9-pin D-sub (female) DDK Ltd.
Signal name
GND (SG)
(P5S)
RXD+ (RDA)
TXD- (SDB)
TXD+ (SDA)
RXD- (RDB)
GND (SG)
(P5S)
Specifications
Tyco International, Ltd
HACHIKO ELECTRIC CO.,LTD.
MITSUBISHI CABLE INDUSTRIES,
LTD.
23.2 Connection Cable
17
18
Manufacturer
19
Remark
Not used
20
Not used
21
22
Manufacture
23
24
23 - 13