Station No. Settings - Mitsubishi GOT1000 Series Connection Manual

21.4.6 Station NO. settings

Set each station number while making sure that one station number is used only once.
The station number can be set without regard to the cable connection order. No problem is expected even if
station numbers are not consecutive.
GOT
(1) Direct specification
When setting the device, specify the station number of the temperature controller of which data is
to be changed.
SDC40A/40B/40G, SDC15, SDC25/26,
SDC35/36, SDC20/21, SDC30/31
DMC10
(2) Indirect specification
When setting the device, indirectly specify the station number of the inverter of which data is to be
changed using the 16-bit GOT internal data register (GD10 to GD 25 ).
When specifying the station No. from 200 to 215 on GT Designer2, the value of GD10 to GD25
compatible to the station No. specification will be the station No. of the temperature controller.
Specification station NO.
(3) All station specification
Target station differs depending on write-in operation or read-out operation.
• For write-in operation, all station will be a target.
• For read-out operation, only one station will be a target.
21 - 42
21.4 Temperature Controller Side Setting
21.4.6 Station NO. settings
Station No.3 Station No.0
Examples of station number setting
Model
Compatible device
200 GD10
201 GD11
202 GD12
203 GD13
204 GD14
205 GD15
206 GD16
207 GD17
208 GD18
209 GD19
210 GD20
211 GD21
212 GD22
213 GD23
214 GD24
215 GD25
Station No.1 Station No.15 Station No.6
Specification range
0 to 127
0 to 15
0 to 127 : For SDC40A/40B/40G, SDC15, SDC25/26,
SDC35/36, SDC20/21, SDC30/31
0 to 15 : For DMC10
For the setting other than the above, a communication timeout error
will occur.
Setting range