Remote Access; Show Remote-Access Protocol Ftp - Hitachi Compute Blade 500 Series User Manual

Show items
None
Message
None
Example
[Updates the LP firmware of bank no.0 with file name "fw.update".]
$ update hvm firmware -f fw.update -b 0
Confirm? (y/[n]):y
I0015 : Update firmware was completed.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
Send the firmware update file with FTP protocol before executing this
command. If you send the firmware update file during firmware update using
this command, the update may fail. If it fails, execute the update again.

Remote access

show remote-access protocol ftp

Command
show remote-access protocol ftp
Description
Shows the setting of connection allowance of FTP.
This command is used to display the following items:
(1) Connection permissions for IPv4 addresses
¢
¢
(2) Connection permission settings for IPv6 addresses
¢
¢
2-208
Whether FTP connections are permitted
Range of IP addresses whose connection is permitted (network
address and subnet mask)
Whether FTP connections are permitted
Range of IP addresses whose connection is permitted (network
address and prefix length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide