Set Timezone - Enterasys C3G124-24 Configuration Manual

set timezone

Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear the SNTP poll timeout:
C3(su)->clear sntp poll-timeout
set timezone
Use this command to configure the current timezone as an offset from UTC.
Syntax
set timezone name [hours] [minutes]
Parameters
name
hours
minutes
Defaults
If you enter a timezone name without specifying an offset in hours and minutes, the default is an
offset from UTC of 0 hours and 0 minutes.
Mode
Switch command, read-write.
Usage
Typically, this command is used to configure the local timezone offset from UTC (Univeral Time)
when SNTP is used to synchronize the time used by devices on the network.
To display the current timezone setting used by SNTP, use the show sntp command. To clear an
existing offset to zero, enter the command without specifying any hours or minutes.
Standard timezone names and offsets can be found at the following URL, among others:
http://www.timeanddate.com/library/abbreviations/timezones/
The name of the timezone. Typically, this name is a standard
abbreviation such as EST (Eastern Standard Time) or EDT (Eastern
Daylight Time).
(Optional) Specifies the offset in hours from UTC. The value can range
from -13 to 13. The default is 0 hours.
(Optional) Specifies additional offset in minutes from UTC. The value
can range from 0 to 59. The default is 0 minutes.
Configuring SNTP
Enterasys C3 Configuration Guide 20-9