Delta ASD-A2 Series User Manual page 543

Chapter 8 Parameters
Setting Value: 0x2C
DO Name
When the value which is monitored by P0-09 is between P0-54～
Zon1
P0-55, then this DO is ON.
Setting Value: When DI.ABSE is ON, DO2 outputs ABSR signal, function set by P2-19 is
disabled.
DO Name
ABSR is DO.ABSR is OFF means the Request sent by ABSQ has been
always received. DO.ABSR is ON means the data that is outputted by
outputted ABSD is valid. When DI.ABSE is ON, this DO is enabled. Please
by DO2 refer to diagram 12.4 for detailed description.
Setting Value: When DI.ABSE is ON, DO3 outputs ABSD signal, function set by P2-20 is
disabled.
DO Name
ABSD is Position data of ABS is outputted. The data is valid when ABSR is
always ON. When DI.ABSE is ON, this DO is enabled. Please refer to
outputted diagram 13.4 for detailed description.
by DO3
Setting Value: 0x30
DO Name
SDO_0 Output the status of bit 00 of P4-06
Setting Value: 0x31
DO Name
SDO_1 Output the status of bit 01 of P4-06
Setting Value: 0x32
DO Name
SDO_2 Output the status of bit 02 of P4-06
8-292
Function Description of Digital Output (DO)
Function Description of Digital Output (DO)
Function Description of Digital Output (DO)
Function Description of Digital Output (DO)
Function Description of Digital Output (DO)
Function Description of Digital Output (DO)
ASDA-A2
Control Mode
ALL
Trigger Control
Method Mode
Level ALL
triggered
Trigger Control
Method Mode
Level ALL
triggered
Trigger Control
Method Mode
Level ALL
triggered
Trigger Control
Method Mode
Level ALL
triggered
Trigger Control
Method Mode
Level ALL
triggered
Revision February, 2017