Delta ASD-A2 Series User Manual page 371

Chapter 8 Parameters
P2-57 SBW
Operational
Interface：
Default： 0
Control
Mode：
Range： 0~1023
Data Size： 16-bit
Format： Decimal
Settings： If users do not know how to set P2-54~P2-56, setting the bandwidth of
P2-58 SVL
Operational
Interface：
Default： 0
Control
Mode：
Range： 0~1000
Data Size： 16-bit
Format： Decimal
Example： 15 = 1.5 ms
Settings： If the synchronous control is influenced by low resolution and causes
P2-59 Reserved
8-120
The Bandwidth of Synchronous Control
Panel / Software
ALL
Unit： Hz
synchronous control value will do since the value will correspond to P2-
54~P2-56. The bigger the bandwidth of synchronous control value is,
the better the synchronous effect will be. When increasing the
bandwidth of speed loop and synchronous control, pay special
attention to the response of P2-25 which should be faster than the
setting of the both bandwidth.
Low-pass Filter of Synchronous Speed Error
Panel / Software
ALL
Unit： 0.1ms
noise (not a high-pitched but rough sound), low-pass filter can be used
to solve this problem. Please note that bandwidth of the synchronous
control should be set as large as possible and should larger than the
bandwidth of speed-loop.
Communication
Communication
ASDA-A2
Address: 0272H
0273H
Related Section: -
Address: 0274H
0275H
Related Section: -
Revision February, 2017