Delta ASD-A2 Series User Manual page 305

Chapter 8 Parameters
Settings：
P1-16 CSOF
Operational
Interface：
Default： 0
Control
Mode：
Range： -32768 ~ +32767
8-54
YX: Threshold of correction (%)
Z: Filter intensity
U: Filter is functioning (read-only)
(It will be provided after the version of V1.0.38 sub15)
YX: When synchronous axis captures the signal, the system will
calculate the error. This function is enabled only when the error is
less than the setting range. Otherwise, the system will use the new
threshold of correction to perform the operation.
YX
Function Disabled
Z
Function
Z: The setting of filter intensity (Bigger value brings less severe change
and better filter effect)
U: Value Definition (read-only):
0: Filter function is disabled. It means the error is greater than Y & X
Range.
1: Filter function is enabled. It means the error is within Y & X range.
If value Z or YX is 0, filter function is disabled.
Capture Synchronous Axis – Offset
Compensation
Panel / Software
PR
Unit： Pulse unit of Capture Axis
00
It will be enabled when error is between 1%
0
Disabled Average of 2^Z: Enabled
Communication
01~05F
and YX%.
1~F
Address: 0120H
0121H
Related Section:
Revision February, 2017
ASDA-A2