Delta ASD-A2 Series User Manual page 309

Chapter 8 Parameters
Format： Decimal
Settings：When multiple points are required to be captured, after each point is
P1-21 CPCL
Operational
Interface：
Default： 0
Control
Mode：
Range： -32768 ~ +32767
Size：
Format： Decimal
Settings：(This function is available in firmware version V1.038 sub48 and later
8-58
captured, the masking range can be set in this parameter. In the
masking area, the CAPTURE function will not work. The masking range
is defined as follows:
(CAP_DATA-P1-20，CAP_DATA+P1-20)
Please note:
When the setting value of this parameter is set to 0, the masking
function is disabled.
E-Cam Pulse Phase Compensation – Min.
Frequency Setting of Master Axis
Panel/Software
PR
Unit： Kpps (Kpulse/sec)
Data
16-bit
models only)
This parameter is used to compensate the delay pulse phase when the
electronic cam function is enabled during operation. Please use this
parameter with P1-18.
Compensated Pulse Phase (pls) = P1-18 x (Pulse Frequency of E-Cam
Master Axis (Kpps) – P1-21)
Please note:
1. The setting value of this parameter is proportioned to the value
of the pulse frequency of E-Cam master axis.
2. The pulse phase compensation function is enabled only when the
setting value of parameter P1-18 is not equal to 0.
3. The pulse phase compensation function is enabled only when the
value of the pulse frequency of E-Cam master axis (monitoring
variable is 060) Pulse number of E-Cam master axis (Incremental))
is higher than the setting value of parameter P1-21.
Communication
ASDA-A2
Address: 012AH
012BH
Related Section: N/A
Revision February, 2017