Delta ASD-A2 Series User Manual page 459

Chapter 8 Parameters
P5-91 CMAN E-CAM: AREA No. - The Point of DO OFF
Operational
Interface：
Default： 0
Control
Mode：
Range： 0 ~ 360
Data Size： 16-bit
Format： Decimal
Settings： When E-cam is engaged, set the end angle of DO output (DO.
P5-92 PLED
Operational
Interface：
Default： 0
Control
Mode：
Range： -2147483648 ~ +2147483647
Data Size： 32-bit
Format： Decimal
Settings： This parameter goes with the selection of P5-88, U=4 (E-cam will
8-208
Panel / Software
PR
Unit： Degree
CAM_AREA).
E-CAM: Pre-engaged Time of Each Cycle
Panel / Software
PR
Unit： -
disengage if it exceeds the moving distance):
After disengaging, it does not enter the Stop status but pre-engaged
status. The lead pulse is determined by this parameter.
The pulse number sent by the Master must exceed the setting value of
this parameter so that E-cam will engage again.
In other words, E-cam will engage not until the lead pulse is ignored.
If the symbol of this parameter is ＋, it means the received positive
pulse will be regarded as the lead pulse.
If the symbol of this parameter is －, it means the received negative
pulse will be regarded as the lead pulse.
Communication
Communication
ASDA-A2
Address: 05B6H
05B7H
Related Section:
7.11
Address: 05B8H
05B9H
Related Section:
7.11
Revision February, 2017