Delta ASD-A2 Series User Manual page 382

ASDA-A2
Data Size： 16-bit
Format： Decimal
Settings： (This function is available in firmware version V1.038 sub26 and later
P2-75■ ALTG E-Cam Alignment - Alignment Target Position
Operational
Interface：
Default： 0
Control
Mode：
Range： 0 ~ (P5-84 /P5-83)-1
Data Size： 32-bit
Format： Decimal
Settings： (This function is available in firmware version V1.038 sub26 and later
P2-76■ ALCT E-Cam Alignment - Source Setting
Operational
Interface：
Default： 0x0000
Control
Mode：
Range： 0x0000 ~ 0x6FF7
Data Size： 16-bit
Revision February, 2017
models)
This parameter is used to set for the compensation of delay time from
digital input.
Panel / Software
PR
Unit： The pulse unit of Master axis
models)
Note: When the input value is over the setting range, an error will occur.
Then, the user cannot input the setting value.
Note: When a correct value is already set in P2-75 and does not
exceed the setting range, if a change on P5-84 or P5-83 cause
the value to exceed the setting range, this parameter will be reset
to 0 automatically.
New value of P2-75 = 0 if P2-75 >=(P5-84 /P5-83)
Panel / Software
PR
Unit： N/A
Communication
Communication
Chapter 8 Parameters
Address: 0296H
0297H
Related Section: N/A
Address: 0298H
0299H
Related Section: N/A
8-131