Delta ASD-A2 Series User Manual page 463

Chapter 8 Parameters
Failure code F035h The protection level, P5-94 exceeds the allowable range
Success code
1003h
Command code
0004h
Macro parameters
This function can be executed when activating the function of parameter protection.
If the protection function is unlocked, repeat execute this function will sent back the
failure code.
If entering the wrong password, failure code Ennn will be sent back. nnn means the
rest decode number. It will be misused one number after one failure. When the
number is 0, it will be locked for good.
Failure code F041h Protection function is unlocked and it cannot repeat unlock.
Failure code F043h The password setting exceed the allowable range
Failure code F044h The number of times of entering wrong password exceeds
Failure code
Ennnh
Success code
1004h
Command
0006h
General
parameters
Macro parameters
8-212
(0~1).
The following macros are available from version V1.026 (included):
Motion parameter protection: unlock the protection
P5-96= enter the password (1~16777215)
(1~16777215)
the limit: Lock for good.
Reset the parameter (P2-08=10) to unlock it is the only
method. However, all parameter will return to the default
value.
Incorrect password setting: Failed to unlock.
nnn: the rest decode number. It will be minuses one number
after one failure. When the number is 0, it will be locked for
good.
The following macros are available from version 1.024 (included):
code Build up E-Cam table: flying shear, including synchronous
area (7 areas)
P5-81= Address of table (Data array)
P5-82 = 7 (This macro is fixed to 7 areas)
P1-44, P1-45 = E-gear ratio (it has to be setup in advance)
P5-94 = A (Deceleration ratio: numerator) x C (Number of
cutter)
P5-95= B (Deceleration ratio: denominator)
P5-96= 1000000 x R x V
Among them:
R (cutting ratio) = L (cutting length)／ℓ (Girth of cutter)
Allowable cutting ratio: (0.3 ~ 2.5) times
Ｖ(Speed factor) = target cutting speed／speed of delivered
product
ASDA-A2
Revision February, 2017