Delta ASD-A2 Series User Manual page 377

Chapter 8 Parameters
Settings： Special-bit Register 2:
P2-67 JSL
Operational
Interface：
Default： 1.5
Control
Mode：
Range： 0 ~ 200.0
Data Size： 16-bit
Format： One decimal
Example： 1.5 = 1.5 times
Settings： In semi-auto mode, if the value of inertia estimation is smaller than P2-
8-126
B7 B6
- -
B0~B1: Reserved
B2: Cancel latch function of low-voltage error
0: Latch function of low-voltage error: the error will not be cleared
automatically.
1: Cancel latch function of low-voltage error: the error will be cleared
automatically.
B3: Reserved
B4: Cancel the detection of AL.044
0: AL.044 will occur
1: AL.044 will be ignored.
B5: Enable disconnection detection of linear scale (only when the full-
closed loop control function is enabled)
0: AL.041 will be ignored
1: AL.041 will occur
B6~B8: Reserved
B9: When AL.003 occurs, switch on DO.ALM or DO.WARN
0: When AL.003 occurs, switch on DO.WARN.
1: When AL.003 occurs, switch on DO.ALM
B10~B15: Reserved.
The Stable Level of Inertia Estimation
Panel / Software
ALL
Unit： 1times
67 and the status remains for a while, the system will regard the inertia
estimation as completed.
B5 B4 B3
- - -
Communication
15
0.1times
0 ~ 2000
Decimal
15 = 1.5 times
ASDA-A2
B2 B1 B0
- - -
Address: 0286H
0287H
Related Section: -
Revision February, 2017