Delete Network Service <Service_Name; Delete Snmp Community <Name; Delete Snmp Trap_Community <Name; Delete Syslog <Ip_Name_Or_Address - 3Com OfficeConnect 3CP4144 Cli User's Manual

B-12 A B: CLI COMMAND DESCRIPTION
PPENDIX
delete network service
<service_name>
delete snmp
community <name>
delete snmp
trap_community
<name>
delete syslog
<ip_name_or_address>
delete tftp client
<ip_name_or_address>
delete user <name>
delete vc <name>

DIAL

dial <vc_name>

DISABLE

disable access

disable bridge network
<name>
disable bridge
spanning_tree
Deletes the specified network service from the list of available services. You must
use disable network service before deleting the service. You can see which services
are available and active using list available services and list services.
Deletes an SNMP community that was previously added with the add snmp
community command. You can use list snmp communities to see the current
entries.
Deletes an SNMP trap community name from the list of names and IP addresses
that are allowed to receive SNMP trap commands. You can use list snmp
communities to see the current entries.
Deletes the specified IP host name or IP address from the list of addresses which
are authorized to receive syslog information. Use list syslog to see the currently
allowed addresses.
Deletes the specified IP host name or IP address from the list of addresses which
are authorized to TFTP. Use list tftp clients to see the currently allowed addresses.
Deletes a user you previously added to the local user table. Use list users to see the
currently defined user, and show user to see the attributes you assigned to that
user using the add user or set user command.
Deletes a virtual channel profile. Use list vc to see the currently defined VCs, and
show vc to see the attributes of a specific VC. A VC must be disabled before it can
be deleted.
Generates an outgoing connection to the location specified by the vc name. You
can use list vcs to list the defined vc profiles, and their current status.
Disables the Access List feature. When disabled, all hosts are permitted to access
the Router's management services.
Disables the bridge network you previously defined using the add bridge network
command. You can see which bridge networks are currently running using list
bridge forwarding.
Disables use of the spanning tree algorithm on bridge networks. The spanning
tree algorithm is required if there is more than one bridge between the same two
LAN segments. You can use list bridge forwarding to see which bridges are
defined, and show bridge network settings to see which options are enabled on a
particular bridge network.