List Snmp Communities Or List Snmp Trap_Communities; List Syslog; List Tcp Connections; List Tftp Clients - 3Com OfficeConnect Remote 812 Cli User's Manual

B-20 A B: CLI COMMAND DESCRIPTION
PPENDIX
list snmp communities
or list snmp
trap_communities

list syslog

list tcp connections

list tftp clients

list udp listeners

list users

list vc

These commands display the defined SNMP communities, which you previously
defined using the add snmp community command. SNMP trap_communities does
not list access.
Community Name - community designation for the IP address


IP address - IP address of a member of the community


Access (Read/Write) - type of access a member has to MIBs


Displays IP addresses which get syslog entries from the system. See add syslog for
more information, and delete syslog command to remove entries. This command
shows:
Syslog - IP address to which syslog entries will be sent


Log Level - reporting level of entries to send


Msg Count - current number of messages sent since system bootup


Also see list facilities and set facilities commands, which let you view and change
log reporting levels for each system facility.
Displays information about all TCP connections. Connection status is defined in
RFC-793.
Local Address - IP address of the local host for this connection


Local Port - TCP port number used by the local connection


Remote Address - IP address of the remote host for this connection


Remote Port - TCP port number used by the remote connection


Status - status of the connection. E.g.: Listen


Displays IP addresses of all users who allowed to use the Trivial File Transfer
Protocol (TFTP) to connect to the system. You must have used add network service
to add TFTP support to the system and used add tftp client to authorize users to
connect.
Displays User Datagram Protocol (UDP) ports being used by the system. These
ports correspond to processes which are receiving UDP data (for example SNMP,
User Management, TFTP service). Local IP addresses and port numbers are listed
for each UDP port.
Lists all users, showing:
User Name - user designation you specified using add user


Login Service - The service used to login to the network (i.e. TELNET).


Status - link status: ACTIVE, INACTIVE or DISABLED


Lists all virtual channel profiles, showing:
Name - user designation you specified using add vc


Network Service - type of network service: RFC1483, PPP, PPPLLC


VPI - Virtual Path Identifier