Set Bridge Firewall [Firewall_Mode]; Set Command; Set Date <Date; Set Dhcp Mode <Mode - 3Com OfficeConnect 3CP4144 Cli User's Manual

B-24 A B: CLI COMMAND DESCRIPTION
PPENDIX
set bridge firewall
[firewall_mode]

set command

set date <date>
set dhcp mode <mode>

set dhcp relay server1

Sets the mode of the Bridge Firewall function. The three modes are completely
described in Chapter 6.
discard_routed_protocols - packets for routed protocols are not bridged.
fwd_unicast_packets_only - unicast packets for routed protocols may also
be bridged. Broadcast and multicast packets are not bridged.
fwd_bc_and_unicast - broadcast, multicast and unicast packets for routed
protocols may also be bridged.
history <numerical range>
idle timout <minutes>
local_prompt <string>
prompt <string>
Sets console parameters for CLI commands.
Parameters
history
<numerical range>
prompt <string>
local_prompt <string>
Sets the system date, and leaves the time unchanged. Use show date to see what
the current settings are. The format is: dd-mmm-yyyy. The month should be the
first three characters of the month name. The year can be either 2 or 4 digits - 97
or 1997.
Sets the DHCP mode for the unit.
Parameters Description
mode DHCP functionality you wish to enable for this unit. Currently available
services are:
DISABLED - disables all DHCP services.
RELAY - enables the DHCP Relay service.
SERVER - enables the DHCP Server within the unit.
address <IP_address>
enabled [YES | NO]
max_hops <number>
Defines the address and characteristics of the primary DHCP Server over the WAN
that should receive our relayed DHCP requests.
Parameters Description
address IP address of the primary DHCP server over the WAN port where DHCP
resolution requests should be forwarded.
Description
Sets the depth of the buffer holding the command history. Use the
history command to see the current depth and a list of your last CLI
commands. The default is 10 commands. The range is 1-500.
Sets the global command prompt for the CLI. Use show command
to see the currently defined prompt. Limit: 64 characters.
Sets a separate prompt for a command file process. Limit: 64
characters.