Rip - 3Com OfficeConnect 3CRWDR200A-75 User Manual

Figure 50 Static Route screen
Please enter the following values in the box respectively to specify a
static route:
Network Address - the network address of the route. If network
address and subnet mask are both set to 0.0.0.0, this is the default
route.
Subnet Mask - the subnet mask of the route. If network address and
subnet mask are both set to 0.0.0.0, this is the default route.
Gateway - the gateway used to route data to the network specified
by the network address.
The network interface associated with the IP address.
The Router supports the Routing Information Protocol (RIP). RIP

RIP

allows you to set up routing information on one RIP enabled device,
and have that routing information replicated to all RIP enabled devices
on the network. LAN and WAN interfaces can be configured
independently of each other.
Select the RIP tab to display the screen shown in
Advanced 75
Figure 51