Enable Telnet Escape; Enable User <User Name; Enable Vc <Vc Name; Exit Cli - 3Com OfficeConnect 3CP4144 Cli User's Manual

B-16 A B: CLI COMMAND DESCRIPTION
PPENDIX

enable telnet escape

enable user <user
name>
enable vc <vc name>

exit CLI

HANGUP

hangup interface
<interface_name>
hangup vc <vc_name>

HELP

help <command>

HISTORY

history
If the TELNET escape character was disabled by the disable TELNET escape
command, this command re-enables it. When enabled, TELNET client users who
press the TELNET escape key during their session will get a TELNET command line.
By default the escape character is control-]. A TELNET user can change it using set
escape in the TELNET program.
Enables a user to establish TELNET sessions for remote management. You must
have previously added the user using the add user command, where enabled is the
default. The list users command displays a summary of all configured user profiles.
Enables a virtual channel to establish data sessions over the WAN. You must have
previously added the VC using the add vc command, where disabled is the default.
The list vc command displays a summary of all configured VC profiles.
If CLI password protection is enabled, this command forces an immediate logout
from the CLI. The CLI password must be entered in order to access the CLI again.
Causes the connection on the specified interface to hangup (drop).
Causes the connection for the specified VC to drop. You can see which VCs have
active connections using list vcs. Also see disable vc, which causes a VC's session to
drop, and prevents new sessions which use that VC from being established.
Provides information about possible commands and their formats. Typing help
alone lists the possible commands. Typing help <command name> lists the
possible parameters for that command.
Typing part of a keyword (command or parameter) and pressing Esc completes the
keyword. If you have not yet entered enough of the keyword to be unique,
pressing Esc causes the bell to ring.
Typing ? after a command string displays the possible keywords and values for that
command.
Displays your previous CLI commands. You can recall commands from the history
using ^P ( C-P) to recall commands up the list, and ^N ( C-N) to recall commands
working down the list. The default depth is 10 commands. You can modify the
history depth using the set command history command.