Change 7; Change 6 - Agilent Technologies ENA Series User Manual

Manual Changes
Manual Changes
Figure A-16 Dimensions (side view, in millimeters, nominal)
Change 8
The firmware revision A.04.00 or below does not support the following functions. Please
disregard the descriptions of these functions in this manual.
o Offset limit line function
o Ripple test function
o Bandwidth test function
o Enhanced response calibration
o Frequency information appearing as asterisks
o Disable USB mass storage devices

Change 7

The firmware revision A.03.62 or below does not support the following functions. Please
delete the descriptions about these functions in this manual.
o Scalar-mixer calibration
o Vector-mixer calibration
o Absolute measurement function and receiver calibration
o Frequency offset function (including the avoid spurious function)
o External signal generator control function
o Point trigger function
o Z/Y Transmission-Shunt conversion
o Imbalance 3 and 4 parameters for SE-SE-Bal measurement (Fixture simulator)
Appendix A 601