Agilent Technologies ENA Series User Manual page 250

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Making Measurements

Setting Up the Trigger and Making Measurements

Step 3. Press the softkey that corresponds to the desired trigger source.

2. Selecting a Trigger Mode

Follow the procedure below to select a trigger mode.

Step 1. Press

Step 2. Press

Step 3. Press the softkey that corresponds to the desired trigger mode.

Hold All Channels

Continuous Disp Channels

Step 4. Repeat Step 1 to Step 3 until each channel is set for its trigger mode.

3. Generating the Trigger

Next, it is necessary to generate a trigger by using the trigger source selected in "1.

Selecting a Trigger Source" on page 243.

Once the internal trigger source is selected, a series of triggers is continuously generated as

soon as the setting becomes effective.

Selects internal trigger source

Selects external trigger source

Selects manual trigger source

Selects bus trigger source

) to select the channel for which the trigger mode will

Sets active channel trigger mode to hold sweep mode

Sets active channel trigger mode to single sweep mode

Sets active channel trigger mode to continuous sweep mode

Sets all channel trigger modes to hold sweep mode

Sets trigger modes of all displayed channels (

to continuous sweep mode

during a sweep forces the analyzer to abort the sweep.

Troubleshooting

E5070b E5071b