Setting The Beeper (Built-In Speaker); Setting The Operation Complete Beeper; Setting The Warning Beeper - Agilent Technologies ENA Series User Manual

Setting the Beeper (Built-in Speaker)

The E5070B/E5071B has a built-in speaker that sounds a beep tone. The beeper allows you
to make two types of settings shown in Table 13-2.
Table 13-2
Operation
complete beeper
Warning beeper
The warning beeper sounds slightly longer than the operation complete beeper.

Setting the Operation Complete Beeper

Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Pressing
complete beeper.

Setting the Warning Beeper

Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Pressing
beeper.
Chapter 13
Setting and Using the Control and Management Functions
Type
Sounds a beep tone to inform the user that operations have
completed.
• When calibration data measurements are done
• When data storage has completed
Sounds a beep tone to prompt the user to use caution.
• When an instrument error occurs (An error message appears at
the same time.)
• When a limit test fails
.
.
Misc Setup
.
Beeper
to switch the operation complete beeper on/off.
Beep Complete
allows you to hear and check the beep tone of the operation
Test Beep Complete
.
.
Misc Setup
.
Beeper
to switch the warning beeper on/off.
Beep Warning
allows you to hear and check the beep tone of the warning
Test Beep Warning
Setting the Beeper (Built-in Speaker)
Function
445