Agilent Technologies ENA Series User Manual page 260

Data Analysis
Analyzing Data on the Trace Using the Marker
Step 4. Select a marker and turn it on. The softkey used to turn on a marker is also used to activate
that marker.
Softkey
Marker 1
Marker 2
Marker 3
Marker 4
More Markers
More Markers
More Markers
More Markers
More Markers
Ref Marker
Step 5. Change the marker stimulus value in the entry area. This operation enables you to move the
marker to a point on the desired trace.
The value in the entry area can be changed by one of the following methods.
NOTE To change the value in the entry area, the figure in the box should be highlighted. If the
figure is not highlighted, press the softkey for the marker you are using (
marker 9
•
•
•
•
You can move the marker by dragging and dropping either one of the marker position
pointers above and below the graph (
and releasing the button on the destination). In rectangular display format, you can move a
marker itself by dragging and dropping it.
Step 6. When using other markers, repeat Step 4 and Step 5.
Step 7. Read the marker stimulus value and marker response value displayed in the upper-left part
of the trace screen.
254
-
Marker 5
-
Marker 6
-
Marker 7
-
Marker 8
-
Marker 9
, ) or
Ref Marker
Enter a numeric value using the ENTRY block key on the front panel.
Turn the rotary knob ( ) on the front panel.
Press the up or down arrow key (
Using the mouse, click one of the buttons (
Function
Turns on marker 1 and activates marker 1
Turns on marker 2 and activates marker 2
Turns on marker 3 and activates marker 3
Turns on marker 4 and activates marker 4
Turns on marker 5 and activates marker 5
Turns on marker 6 and activates marker 6
Turns on marker 7 and activates marker 7
Turns on marker 8 and activates marker 8
Turns on marker 9 and activates marker 9
Turns on the reference marker and activates reference marker
to highlight the figure.
) on the front panel.
) on the right side of the entry area.
) (pressing the button on the object to be moved
to
marker 1
Chapter 6