Agilent Technologies ENA Series User Manual page 77

Setting the Sweep Range with the Lowest and Highest Values
Step 1. Press
Step 2. Press
Step 3. Using the ENTRY block keys on the front panel, input the lowest value.
Step 4. Press
Step 5. Using the ENTRY block keys on the front panel, input the highest value.
Setting the Sweep Range with the Center Value and a Span
Step 1. Press
Step 2. Press
Step 3. Using the ENTRY block keys on the front panel, input the center value.
Step 4. Press
Step 5. Using the ENTRY block keys on the front panel, input a span value.
Setting the Sweep Range Using the Marker
Step 1. In the channel window whose range must be set, place the active marker on the active trace
to a position that corresponds to the new range (to the lowest, highest, or center value).
Step 2. Press
Step 3. Press the softkey that corresponds to each value.
Softkey
Marker → Start
Marker → Stop
Marker → Center
NOTE If the reference marker is on and the stimulus value of the active marker is expressed by a
value relative to the reference marker, the absolute stimulus value will be used to set the
new sweep range.
Chapter 3
or to select the channel whose sweep range will be set.
.
.
or to select the channel whose sweep range will be set.
.
.
.
Function
Sets the lowest value to the stimulus value of the active marker on the
currently active trace.
Sets the highest value to the stimulus value of the active marker on the
currently active trace.
Sets the center value to the stimulus value of the active marker on the
currently active trace.
Setting Measurement Conditions
Setting Stimulus Conditions
71