Agilent Technologies ENA Series User Manual page 245

Figure 4-78 Connection of power sensor
Step 4. Press
Step 5. Press
Step 6. Press
Step 7. Press
Step 8. Press
Step 9. Connect the test port you selected in Step 1 to the ECal module, as shown in Figure 4-79,
and then press
NOTE If the ECal module is not connected to the E5070B/E5071B, the
will not be not available. In addition, if the ECal module is not connected to the test port of
the calibration target, an error may occur. For information on connecting the ECal module,
see "ECal (electronic calibration)" on page 127.
Chapter 4
.
Port x@Freq x
.
Port x@Freq y
.
Port y@Freq x
.
Port y@Freq y
.
Return
.
ECal & Done
Calibration
Scalar-Mixer Calibration
menu item
ECal & Done
239