Setting The E5091A; Selecting Id For E5091A - Agilent Technologies ENA Series User Manual

Controlling E5091A

Setting the E5091A

Setting the E5091A
This section describes the settings of the E5091A. Table 14-1 shows the flow used for item
setting.
Table 14-1 Setting flow for E5091A
Item
"Selecting ID for E5091A" on page 476
"Selecting the E5091A Model" on
page 477
"Assigning test ports" on page 477
"Displaying the E5091A properties" on
page 479
"Setting control line" on page 480
"Enabling control of E5091A" on
page 481

Selecting ID for E5091A

Set the target ID to the ID of the connected E5091A.
Step 1. Press
Step 2. Select
rear panel of the E5091A (Figure 14-3).
NOTE Change the ID bit switch setting while the E5070B/E5071B is turned off.
Figure 14-3 ID bit switch of E5091A
476
-
Multiport Test Set Setup
for ID 1 and
Test Set 1 Test Set 2
Description
Selects the ID of the E5091A you want to
set
Selects the E5091A model you want to set
Assigns test ports of the E5070B/E5071B
and those of the E5091A
Displays the E5091A property to check the
port setting
Makes the setting of the control line that
controls the DUT
Enables functions to control the E5091A
to display the E5091A setup menu.
for ID 2. The ID is set with the bit switch on the
Chapter 14