Create A Segment Sweep Table - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Measurement Examples

Evaluating a Duplexer

2. Create a Segment Sweep Table

Entries are made in the segment sweep table following the steps described below.

Step 1. Display the segment table.

Setup Description

Displaying the segment table

Step 2. Enter the setup data in the segment table (Figure 15-7).

In this step, the IF Bandwidth, power level, delay time, and sweep time are not entered

segment by segment. By turning off the display of those parameters on the segment table,

you can use, in each segment without making a change, the IF Bandwidth (preset value: 70

kHz) of the channel specified by using

dBm) of the channel specified by using

value: 0 second) of the channel specified by using

mode (preset value: Stepped mode) of the channel specified by using

Completed segment table

; and Sweep time (preset value: Automatic) of the channel specified by using

Key Operation

Edit Segment Table

; Power level (preset value: 0

IF Bandwidth

; Sweep delay time (preset

E5070b E5071b