Agilent Technologies ENA Series User Manual page 192

Calibration
Changing the Calibration Kit Definition
Step 4. Press . To change the pre-defined connector type (e.g. OPEN(f) to OPEN (m))
Modify Kit
skip to Step 14.
Step 5. Press
Define STDs
Step 6. Select the standard to be redefined from among standards numbered 1 through 21.
Step 7. Press .
STD Type
Step 8. Select the type of standard according to the list below.
Softkey
Open
Short
Load
Delay/Thru
Arbitrary
None
Step 9. Set the standard coefficient according to the list below.
Softkey
C0
C1
C2
C3
L0
L1
L2
L3
Offset Delay
Offset Z0
Offset Loss
Arb. Impedance
Min. Frequency
Max. Frequency
Connector Type
*1.Specify 1 Ω when Waveguide is set for the media type.
*2.Specify cutoff frequency when Waveguide is set for the media type.
186
.
Function
Selects the OPEN standard
Selects the SHORT standard
Selects the LOAD standard
Selects the delay/THRU standard
Selects the arbitrary impedance
Selects no standard type
Function
Sets C0
Sets C1
Sets C2
Sets C3
Sets L0
Sets L1
Sets L2
Sets L3
Sets the offset delay
*1
Sets the offset Z0
Sets the offset loss
Sets an arbitrary impedance
Sets a start frequency.
Sets a stop frequency.
Selects a media type.
*2
*2
Chapter 4