Agilent Technologies ENA Series User Manual page 295

Step 5. Press
Step 6. Select a matching circuit model (Figure 7-5).
Softkey
None
Series L - Shunt C
Shunt C - Series L
Shunt L - Series C
Series C - Shunt L
Shunt L - Shunt C
User
Step 7. Specify the values of the elements in the selected circuit model.
Softkey
C
G
L
R
NOTE When either of the two components of Series-C, "C" and "G", is set to 0, the component is
defined as "Open"; when both components are set to 0, they are defined as "Short."
When either of the two components of Shunt-L, "L" and "R", is set to 0, the component is
defined as "Short"; when both components are set to 0, they are defined as "Open."
Step 8. Repeat Step 3 to Step 7 to set up the matching circuit for each port used.
Step 9. Press
Step 10. Press
Step 11. If
Fixture Simulator
Chapter 7
Determining Characteristics After Adding a Matching Circuit
.
Select Circuit
Function
No matching circuit is added.
Selects a circuit model consisting of a series inductor and a shunt
capacitor
Selects a circuit model consisting of a shunt capacitor and a series
inductor
Selects a circuit model consisting of a shunt inductor and a series
capacitor
Selects a circuit model consisting of a series capacitor and a shunt
inductor
Selects a circuit model consisting of a shunt inductor and a shunt
capacitor
Selects the circuit model defined in the user file imported by
performing Step 4
Function
Specifies capacitance [F]
Specifies conductance [S]
Specifies inductance [H]
Specifies resistance [Ω]
to turn the matching circuit function
Port Matching
.
Return
is , press the key again to turn it
OFF
Fixture Simulator
.
ON
.
ON
289