Agilent Technologies ENA Series User Manual page 433

Step 2. Confirm that VISA Interface Name is set to GPIB0 (1 in Figure 13-1) and SICL Interface
Name is set to hpib7 (2 in Figure 13-1) and then click the
If the setting is correct, the procedure is complete. If the setting is different, click the
button (4 in Figure 13-1).
Step 3. The USB to GPIB Configuration dialog box (Figure 13-2) appears. Make the setting
enclosed in the thick lines in Figure 13-2 (1 in Figure 13-2) according to the figure and then
click the
Figure 13-2 USB to GPIB Configuration dialog box
If you need to check/change the setting of the USB/GPIB interface after connecting the
USB/GPIB interface, follow these steps:
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. The IO Config dialog box (Figure 13-3) appears. Select (highlight)
Figure 13-3) and then click the
NOTE In the IO Config dialog box, do not click buttons other than specified here or do not change
other settings because doing so may cause serious damage to the functions of the
E5070B/E5071B.
Chapter 13
Setting and Using the Control and Management Functions
button (2 in Figure 13-2).
OK
.
.
Misc Setup
.
GPIB Setup
System Controller Configuration
Edit
button (3 in Figure 13-1).
Accept
.
button (2 in Figure 13-3).
Setting the GPIB
Edit
(1 in
GPIB0 hpib7
427