Determine The Segment Sweep Conditions - Agilent Technologies ENA Series User Manual

1. Determine the Segment Sweep Conditions

Figure 15-1 shows the results of evaluating the transmission characteristics of the SAW
bandpass filter in the range of 440 MHz to 3 GHz by using the linear sweep.
Figure 15-1 Transmission characteristics of SAW bandpass filter (440 MHz to 3 GHz, linear
sweep)
The measurement conditions are determined for each frequency range. Here, the segment
sweep is performed following the sweep conditions shown in Table 15-2.
Table 15-2 Determining Sweep Conditions (using markers shown in Figure 15-1)
Chapter 15
Measuring the SAW Bandpass Filter Using the Segment Sweep
Frequency Range
Start Stop
915 MHz
440 MHz
(Marker 1)
915 MHz 980 MHz
(Marker 1) (Marker 2)
980 MHz 1.035 GHz
(Marker 2) (Marker 3)
1.07 GHz 2 GHz
(Marker 4) (Marker 5)
2.6 GHz
3 GHz
(Marker 6)
Measurement Examples
Measurement Conditions
Number of Points IF Bandwidth
47 70 kHz
130 100 kHz
55 70 kHz
93 70 kHz
41 70 kHz
487