Procedure To Execute The User Recovery Function (2) - Agilent Technologies ENA Series User Manual

Rf network analyzers
Hide thumbs Also See for ENA Series:
Table of Contents

Advertisement

Procedure to execute the user recovery function (2)

This procedure is valid for the E5070B : MY42300633, and above, E5071B : Y42301397
and above. If your unit doesn't follow the procedure written below, please refer to
"Procedure to execute the user recovery function (1)" on page 458 for the detail.
Returns the contents of the C drive to a user-specified state. To use this function, you must
create the user backup image in advance. For more information, see the description
"Procedure to create the user backup image (1)" on page 455.
NOTE
This function is available when the volume label on the hard disk is CP600 or higher.
NOTE
You need the keyboard for this operation.
Step 1. Shut down the E5070B/E5071B.
Step 2. Connect the keyboard to the E5070B/E5071B.
Step 3. Insert the disk for the system recovery into the floppy disk drive of the E5070B/E5071B.
Step 4. Press the standby switch of the E5070B/E5071B to turn it on.
Step 5. When the screen as shown in the figure below appears, press and hold
keyboard until this screen disappears.
NOTE
After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
Chapter 13
Setting and Using the Control and Management Functions
System Recovery
of the
467

Advertisement

Table of Contents
loading

This manual is also suitable for:

E5070bE5071b

Table of Contents