Agilent Technologies ENA Series User Manual page 466

Setting and Using the Control and Management Functions
System Recovery
Step 8. The message as shown below appears. Press
user recovery, press
You chose to recover your own system backup image file.
WARNING: Press C to Continue only if you are sure that you want
to proceed.
chance of recovering any data.
from a serious malfunction caused by corrupted or inadvertently
deleted files on the system's primary C: partition.
Press C to Continue or E to Exit: _
Step 9. The message as shown below appears. Press
If you want to cancel the user recovery, press
CAUTION! Interrupting this process may leave the system in an
Press C to Continue or E to Exit: _
CAUTION Never turn off the power during the system recovery because doing so may cause
serious damage to the E5070B/E5071B.
Step 10. The user recovery will be complete in about 5 minutes. When the user recovery is
complete, the message as shown below appears. Press
keyboard at the same time to restart.
Remove the disk and Press CLT+ALT+DEL to restart your
system.
NOTE If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
460
here.
The C: partition will be completely overwritten with no
unstable state. Allow the software to complete the
backup and recovery process.
minutes depending on the system configuration.
of the keyboard. If you want to cancel the
Use Option 3 to recover the system
of the keyboard to start the user recovery.
here.
This may take up to 20
, , and of the
Chapter 13