System Recovery; Types Of System Recoveries; Notes On Executing System Recovery - Agilent Technologies ENA Series User Manual

Setting and Using the Control and Management Functions

System Recovery

By executing system recovery, you can return the system of the E5070B/E5071B (the
Windows operating system and the firmware) to the factory state (at the time of
*1
purchase ).
The system recovery procedures vary depending on the mother board the E5070B/E5071B
is equipped with. The recovery procedures are indicated for each serial number of the
factory-equipped mother board type; they may not conform to the actual board, if it was
replaced for servicing. In this case, follow the step (2) below to perform a system recovery.

Types of system recoveries

The following two types of system recoveries are available.
Factory recovery
Returns the contents of the C drive to the factory state.
*2
User recovery
Returns the contents of the C drive to a user-specified state. To use this function, you
must prepare for recovery in advance. For information on preparation, see "Procedure
to create the user backup image (1)" on page 455 or "Procedure to create the user
backup image (2)" on page 464 for information on the execution. Also, see "Procedure
to execute the user recovery function (1)" on page 458 or "Procedure to execute the
user recovery function (2)" on page 467.

Notes on executing system recovery

Executing system recovery causes the following:
In addition to the Windows operating system and the firmware, the following settings
of the E5070B/E5071B are returned to the factory state.
• Network setting
• GPIB setting
• Printer setting
The driver for the supported printer installed after purchase is deleted.
You need to execute initial registration again.
Files you created using the save function (files in the D drive) are not affected, but we
recommend backing them up before executing system recovery for precautionary
purposes. For more information on backup, refer to "Making Backup Files" on page 576.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
*2.This function is available when the volume label on the hard disk is CP600 or higher.
Chapter 13
System Recovery
451