Agilent Technologies ENA Series User Manual page 463

Step 8. The message as shown below appears. Press
create user backup image, press
You chose to create a backup image file of your system.
The system will perform a quick integrity check of the file
structure on the C: Drive.
an image file and store it on the System Recovery partition.
Press C to Continue or E to Exit: _
Step 9. The message as shown below appears. Press
backup image. If you want to cancel the create user backup image, press
CAUTION! Interrupting this process may leave the system in an
Press C to Continue or E to Exit: _
CAUTION Never turn off the power during the create user backup image because doing so may
cause serious damage to the E5070B/E5071B.
Step 10. The create user backup image will be complete in about 5 minutes. When the create user
backup image is complete, the message as shown below appears. Press
Remove the disk and Press CLT+ALT+DEL to restart your
system.
NOTE
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
Chapter 13
Setting and Using the Control and Management Functions
here.
unstable state. Allow the software to complete the
backup and recovery process.
minutes depending on the system configuration.
of the keyboard at the same time to restart.
of the keyboard. If you want to cancel the
It will then copy the C: partition to
of the keyboard to start the create user
This may take up to 20
System Recovery
here.
, , and
457