Setting Control Line - Agilent Technologies ENA Series User Manual

Controlling E5091A
Setting the E5091A

Setting control line

The E5070B/E5071B can control the output from the control line (Figure 14-5) of the
E5091A and control the DUT (for example, switching the frequency band of the front end
module). The procedure is shown below. For the specifications of the DUT control line,
refer to E5091A Users & Service Guide.
Figure 14-5 Control line
Operational procedure
Step 1. Press
Step 2. Press
control line.
Step 3. After the execution of "Selecting ID for E5091A" on page 476 and "Selecting the E5091A
Model" on page 477, press
line.
Step 4. Use the corresponding softkey to set the control line of the E5091A.
Softkey
Line 1
Line 5
Step 5. Execute Step. 3 through Step. 4 for all channels that you want to sweep.
480
-
E5091A Setup
or
Control Lines
Function
, , , , Set
Line 2 Line 3 Line 4
, , ,
Line 6 Line 7 Line 8
to display the E5091A setup menu.
to activate the channel for which you want to set the
to display the settings menu for the DUT control
/ of each line of the control line.
High Low
Chapter 14