Procedure - Agilent Technologies ENA Series User Manual

Procedure

Creating a segment table
Step 1. Press
segment table.
Step 2. Press
Step 3. Press
The segment table appears in the lower part of the screen.
Step 4. To change the frequency range setting mode or to set the IF bandwidth, power level, sweep
delay time, sweep mode, and sweep time for each segment, use the following softkeys.
NOTE When setting the segment table using the front panel keys or keyboard, you need to place
focus on (select) the operation target (segment table of softkey) first. You can change the
focus by pressing
table, the window frame of the segment table is displayed as bright as the window frame of
the active channel. When the focus is placed on the softkey menu, the softkey menu title
area is displayed in blue.
Softkey
Freq Mode
List IFBW
List Power
List Delay
List Sweep Mode
List Time
Chapter 12
Performing a Segment-by-Segment Sweep (segment sweep)
or
.
.
Edit Segment Table
in the ENTRY block. When the focus is placed on the segment
Function
Switches the frequency range setting mode (start/stop or center/span)
Toggles ON/OFF the IF bandwidth setting for each segment; the row for
setting ( ) only appears in the segment table when this is ON
IFBW
Toggles ON/OFF the power level setting for each segment; the row for
setting ( ) only appears in the segment table when this is ON
Power
Toggles ON/OFF the sweep delay time setting for each segment; the row for
setting ( ) only appears in the segment table when this is ON
Delay
Toggles ON/OFF the sweep mode setting for each segment; the row for
setting (
Sweep Mode
Toggles ON/OFF the sweep time setting for each segment; the row for
setting ( ) only appears in the segment table when this is ON
Time
Optimizing Measurements
to select the channel for which you want to create the
) only appears in the segment table when this is ON
419