Agilent Technologies ENA Series User Manual page 426

Optimizing Measurements
Performing a Segment-by-Segment Sweep (segment sweep)
Step 5. Enter each item in the following table for each added segment (line) to create the segment
table.
Start
Stop
Center
Span
Points
IFBW
Power
Delay
Sweep Mode
Time
To create the segment table, use the following keys.
Hardkey
Softkey
Delete
Add
Clear Segment Table
OK
420
Sets the start value of the sweep range
Sets the stop value of the sweep range
Sets the center value of the sweep range
Sets the span value of the sweep range
Sets the number of points
Sets the IF bandwidth
Sets the power level; the power range is common to the settings for the
linear/log sweep (
Sets the sweep delay time
Sets the sweep mode; you need to select one of the following items:
Stepped mode
STD STEPPED
Swept mode
STD SWEPT
Fast stepped mode
FAST STEPPED
Fast swept mode
FAST SWEPT
Sets the sweep time; to specify the auto setting (
time
Function
If you select a cell and then press this key, you enter the mode that allows
you to edit the cell character by character. If you change a value and then
press this key, the value is entered in the cell.
Moves up and down in the cell selected in the segment table. In the
character-by-character edit mode, you can select an item or perform a
stepwise change of data.
Moves left and right in the cell selected in the segment table.
Function
Deletes the line containing the selected cell.
Adds a new line above the line containing the selected cell.
- Resets the segment table. As a result, the initialized segment 1 remains.
- )
Power Ranges
), enter 0 as the sweep
AUTO
Chapter 12