Agilent Technologies ENA Series User Manual page 428

Optimizing Measurements
Performing a Segment-by-Segment Sweep (segment sweep)
Executing segment sweep
To execute a segment sweep by using the segment table you have created, you must specify
the sweep type for that sweep operation by following the steps below.
Step 1. Press
segment sweep operation.
Step 2. Press
Step 3. Press
Sweep Type
Step 4. Press .
Segment
Setting up the segment display
Define the method of displaying traces when the segment sweep is executed by following
the steps described below.
Step 1. Press
segment display.
Step 2. Press
Step 3. Press
Segment Display
Step 4. Select the segment display.
Softkey
Freq Base
Order Base
422
(or ) to select the channel on which you will execute the
.
.
(or ) to select the channel on which you will define the
.
.
Function
Displays the X-axis as the axis for linear frequencies (frequency-based
display)
Displays the X-axis as the axis for the points (order-based display)
Chapter 12