Removing/Mounting Removable Hard Disk; Removing Removable Hard Disk; Mounting Removable Hard Disk - Agilent Technologies ENA Series User Manual

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

Removing/Mounting Removable Hard Disk

This section provides information on how to mount and remove a removable hard disk as

well as write the system correction data. Whether a hard disk is removable can be

ascertained by referring to the serial number. For further information, see "Change 9" on

page 600 in the "Manual Changes."

For calibration or repair of the E5070B/E5071B, send it with the removable hard disk

If you replace the removable hard disk, make sure to retrieve the system correction data

from the backup memory. For detailed procedures, refer to"Writing System Correction

Data from Backup Memory to Removable Hard Disk" on page 579.

If you require a backup removable hard disk, we recommend that you purchase the

E5070U/E5071U-Opt018 hard disk drive.

Follow the steps below to remove a removable hard disk.

Before removing a hard disk, you must turn off the unit's power and then disconnect the

power cord from the outlet.

Step 1. Unscrew the four screws that hold the cover panel (1 in Figure 18-1, P/N 0515-2146).

Step 2. Remove the panel.

Step 3. Unscrew the four screws that hold the removable hard disk (1 in Figure 18-2,

P/N0515-0374).

Step 4. Carefully remove the flat cable (2 in Figure 18-2, P/N E5070-61638.

removable hard disk. Release the cable's connector by pressing the locking hooks at the

sides of the connector.

Follow the steps below to mount a removable hard disk.

Step 1. Connect the removable hard disk to the flat cable's connector (2 in Figure 18-2).

Step 2. Secure the removable hard disk in place with the four screws (1 in Figure 18-2).

Step 3. Secure the cover panel in place with the four screws (1 in Figure 18-1).

*1.Flat cable with connector outfitted

Information on Maintenance

Removing/Mounting Removable Hard Disk

E5070b E5071b