Change 13; Change 12 - Agilent Technologies ENA Series User Manual

Change 14
The firmware rivision A.06.50 or lower does not support the following functions. Please
delete the descriptions about these functions from this manual.
o Equation editor function
o User definition variable function
o Function to trigger only the active channel
o Change of the dialog box for checking the puroduct information
o Calibration kits, 85038A/F/M, have been added
o Available power meters, N1911A/N1912A, have been added.
o Function to remove/insert adapter characteristics.
o Unknown Thru Calibration function

Change 13

The firmware rivision A.06.00 or lower does not support the following functions. Please
delete the descriptions about these functions from this manual.
o Low latency external trigger function
o Averaging trigger function
o Function of tolerance setting at power calibration
o Function of trigger source setting at calibration
o Function of data saving in touchstone format by using front panel
o Function of simplified full 3/4 port calibration by using front panel
o Simplified 3/4 port TRL calibration function
o Partial overwrite function

Change 12

For the TRL/LRM calibration with the firmware version A.06.00 or lower, follow the steps
below.
Performing TRL/LRM Calibration
Use the following VBA macro to perform the TRL/LRM calibration.
Folder
D:\Agilent
This VBA macro lets you perform 2-/3-/4-port TRL/LRM calibration for any selected port.
TRL/LRM calibration provides a level of accuracy equivalent to full 2-/3-/4-port
calibration using short, open, thru (SLOT) standards.
To perform TRL calibration, you need to prepare thru, reflection (open or short), and line
standards. The thru and line must have the same reference impedance Z0 and transfer
Appendix A
VBA macro name (project name)
TRL_LRM_cal.vba
Manual Changes
Manual Changes
585