List Of Default Values, Save/Recall Settings, And Backup Settings - Agilent Technologies ENA Series User Manual

List of Default Values

List of Default Values, Save/Recall Settings, and Backup Settings

List of Default Values, Save/Recall Settings, and Backup
Settings
The table below shows the following settings for the Agilent E5070B/E5071B.
•
•
•
•
•
•
In the table, the ← symbol shows that the setup is the same as that in the box to the left.
NOTE
630
Factory-shipped settings
Settings valid when you press
command)
Settings valid when you execute the *RST command
Settings that permit Save/Recall of a setup state
In the table, states that can be saved/recalled are denoted in the following manner:
√: Save/Recall can be performed
Blank: Save/Recall cannot be performed
Settings that are backed up (set state not affected by turning power ON/OFF)
In the table, a setting that is automatically backed up is denoted in the following
manner:
√: Backup operation performed
Blank: Backup operation not performed
Available means of defining a setting
In the table, the following symbols are used to denote the method(s) that can be used to
define a setting.
K: Using the front panel key (including the mouse and keyboard)
C: Using the SCPI command or COM object
(Or when you execute the :SYST:PRES
Appendix C