Agilent Technologies ENA Series User Manual page 371

Rf network analyzers

Hide thumbs Also See for ENA Series:

Table of Contents

LogMag/Angle

LinMag/Angle

Real/Imaginary

Step 5. Press the softkey for

Step 6. Press the softkey that corresponds to the combination of ports that you want to save. For

example, when pressing

If you want to save the data of the channel for which port 1, port 2, and port 4 are

measured, press

Step 7. SaveAs dialog box opens. For its operations, use an external keyboard and mouse. For

Save As dialog box, refer to Figure 10-1, "Save As dialog box," on page 355.

Step 8. Specify the folder to which the file should be saved, enter a file name, and then press

to save the file.

When saving data in a sweep process, the data during sweep is saved into a Touchstone

file. That is, the previous sweep data is saved as data that has not been swept; or, if sweep

was not performed previously, zero data might be saved. Therefore, you should set the

active channel to the HOLD state when saving data into a Touchstone file.

Select "log magnitude - angle" data format

Select "linear magnitude - angle" data format

Select "real - imaginary number" data format

When the display format of the active trace is set to one other than log magni-

tude format (LogMag), linear magnitude format (LinMag), or real-imaginary

number format (Real/Imag), the data format is automatically set to real-imagi-

nary number.

in Step5, softkeys displayed are

Saving Trace Data to a File

according to the file type you want to save.

Troubleshooting

E5070b E5071b