Step 11. Press
Step 12. Press
Figure 8-11
Example of conversion loss measurement
Step 13. Change the frequency data to the desired frequency as required. For detailed information
on changing the frequency data, see "Procedures for changing frequency data" on page
321.
NOTE
For additional information about the absolute measurements, see Agilent application note
1463-6 "Accurate Frequency-Translating Device Measurements by using the
Frequency-Offset Mode, 5989-1420EN".
Chapter 8
to set
(group delay) to Trace 3.
Group Delay
to use
for trace scale optimization (Figure 8-11).
Auto Scale All
Frequency-Offset Measurement (Option 008)
Measurement of Mixers
325