2. Setting the Measurement Conditions
Follow the procedure below to set the measurement conditions. The measurement
parameters for balanced measurements should be set after unbalanced-balanced
conversion. Here, set the measurement parameters for observing the characteristics
achieved during unbalanced measurements.
Setting Description
Preset for setting
Center frequency: 940 MHz
Frequency span: 200 MHz
Number of traces: 2
Trace-1 measurement parameter: S
Trace-2 measurement parameter: S
Allocate a trace to upper and lower displays
Auto-scale all traces
Figure 15-27
Results of unbalanced measurements
Chapter 15
Measuring an Unbalanced and Balanced Bandpass Filter
Key Operation
21
31
Measurement Examples
-
OK
-
-
Num of Traces
2
-
S21
-
S31
-
-
Allocate Traces
-
Auto Scale All
511