Agilent Technologies ENA Series User Manual page 275

Figure 6-12 Peak search (when peak polarity is positive)
Executing a Peak Search
Step 1. Following Step 1 to Step 4 in "Reading values on the trace" on page 253, activate the
marker you are using for the peak search.
Step 2. Press
Step 3. Press
Step 4. Press
This sets the peak search to be executed based on the definitions of the newly set lower
limit for the peak excursion value and the currently set peak polarity.
Step 5. Press
Step 6. Select a peak polarity.
Softkey
Positive
Negative
Both
This sets the peak search to be executed based on the definitions of the currently set lower
limit for the peak excursion value and the newly set peak polarity.
Step 7. Press the corresponding softkey to move the marker to the peak.
Softkey
Search Peak
Search Left
Search Right
NOTE When the data format is in Smith chart or polar format, execute the search for the main
response value of the two marker response values.
Chapter 6
Searching for Positions that Match Specified Criteria
.
.
Peak
and enter the lower limit for the peak excursion value.
Peak Excursion
.
Peak Polarity
Function
Selects Positive as peak polarity
Selects Negative as peak polarity
Selects Both Positive and Negative as peak polarity
Function
Executes peak search
Executes left search
Executes right search
Data Analysis
269