Agilent Technologies ENA Series User Manual page 180

Calibration
User-characterized ECal
6. Storing the User Characteristics to the Memory
Step 1. When the measurement is complete, the User Characteristic Store screen shown in Figure
4-49 appears.
Specify a user number (a location number in the memory where you want to store the user
characteristics) using 1 in Figure 4-49. If the specified location number is not used for
storage, the parts Characterization, Connectors, and Adapter Description are left blank; if
already used, the stored contents are displayed.
Figure 4-49 User Characteristic Store screen
Step 2. Enter the following information.
Characterization
(2 in Figure 4-49)
Connectors
(3 in Figure 4-49)
Adapter Description
(4 in Figure 4-49)
The information you have entered is displayed when checking the user characteristics
information by using the key strokes:
Step 3. Press
At this time, if user characteristics are already stored for the specified user number, a
dialog appears to confirm overwriting. Click the
NOTE Although the maximum number of user characteristics stored to the ECal's memory is
usually five, this number may be limited by memory size because the size of
user-characteristics data is not fixed and increases in proportion to the number of
measurement points. An error occurs when the
added the new user characteristics exceeds this limitation due to memory size.
174
Enter the information (operator, used analyzer, and so on) when
measuring user characteristics as necessary.
Select the connector types of the adapters for the ECal module's test
ports. Male and female in the list of connected types indicate male and
female adapter, respectively. Select "No adapter" if no adapter is used on
a port.
Enter the detailed information on the adapters connected to each port as
necessary.
(5 in Figure 4-49).
Write
- -
ECal Characterization Info
button.
OK
button is pressed if the total size
Write
.
Chapter 4