Agilent Technologies ENA Series User Manual page 335

Figure 8-14 Connection of DUT
Procedures for setting measurement parameters
Follow the steps below to set the measurement parameters. In this case, we measure the
harmonic distortion magnitude by using the frequency-offset sweep and the absolute
measurement function, based on the E5070B/E5071B's internal signal source.
NOTE Receiver calibration is required before starting absolute measurement. For detailed
information on receiver calibration, see "Receiver Calibration" on page 220.
Step 1. Press
which you want to implement absolute measurement.
Step 2. Press
Step 3. Press
stimulus port and test port are set to 1 and 2, respectively.
Step 4. In this case, the segment sweep function is used to perform faster measurement. For
detailed information on segment sweep, see "Performing a Segment-by-Segment Sweep
(segment sweep)" on page 415.
Step 5. Press
Step 6. Set
Frequency Mode
Step 7. Refer to Table 8-5 to input numbers in the segment table, and then press
the "Sweep Setup Menu."
Table 8-5 Segment Table Settings
Center
500 MHz
1 GHz
2 GHz
Chapter 8
(or
to display the "Measurement Menu."
to select absolute measurement parameters (
Absolute
-
Edit Segment Table
to
Center/Span
Frequency-Offset Measurement (Option 008)
Measurement of Harmonic Distortion
) and (or
B (1)
to display the "Edit Segment Table Menu."
.
Span
0 Hz
1 MHz
1 MHz
) to activate the trace for
). Accordingly, the
to return to
Return
Point
1
5
5
329