Agilent Technologies ENA Series User Manual page 243

Step 9. Connect the OPEN calibration standard to the test port x (connector for the DUT) you have
selected in Step 6.
Step 10. Press
Step 11. Press
Step 12. Disconnect the OPEN calibration standard you connected in Step 9 and then connect
SHORT calibration standard in its place.
Step 13. Press
Step 14. Press
Step 15. Disconnect the SHORT calibration standard you connected in Step 12 and then connect
LOAD calibration standard in its place.
Step 16. Press
Step 17. Press
Step 18. Follow steps Step 9 to Step 17 for port y.
Step 19. Press
Step 20. Press
Step 21. Connect a THRU between the test ports x and y (between the connectors for the DUT) you
selected in Step 6.
Step 22. Press
Step 23. Press
Step 24. Press
Step 25. Press
NOTE In scalar-mixer calibration, the power meter is used. For more on how to set the power
meter, see "Preparing to control the power meter" on page 210.
Step 26. Press
If you are using a one-channel power meter, select Channel A.
Step 27. Connect the power sensor for the selected channel to the selected port, as shown in Figure
4-77.
Chapter 4
to start measurement of the calibration standard.
Port x @Freq x Open
to start measurement of the calibration standard.
Port x @Freq y Open
to start measurement of the calibration standard.
Port x@Freq x Short
to start measurement of the calibration standard.
Port x@Freq y Short
to start measurement of the calibration standard.
Port x@Freq x Load
to start measurement of the calibration standard.
Port x@Freq y Load
.
Return
.
Transmission
to start measurement of the calibration standard.
Port y-x@Freq y Thru
to start measurement of the calibration standard.
Port x-y@Freq x Thru
.
Return
.
Power Meter
. Each time the key is pressed, Channels A and B switch over alternately.
Use Sensor
Calibration
Scalar-Mixer Calibration
237